Certified Modular Training
E-Learning or In-person because Knowledge does not take up space
ANDApplications are now open for the next Power Plant Reprogramming training.
Our commitment:
After training, all trainees will be able to to develop all course objectives independently.
We will always be available to support or clarify any questions.
Constant support after training. (telephone support; email and creation of an online support group)
Information:
No experience required.
We provide all the necessary material for the course.
At the end, all trainees will be given a pen with all the training content, as well as all the programs needed to be able to work.
A training certificate will also be delivered.
You will be added to an online group where you can clarify doubts, ask for constant and on-the-spot help, etc.
Attention:
Limited spaces.(only 6 trainees, so that everyone can properly learn all the content. )
Level 1 Training
Online or in person
Duration 8 hours
At the end of the course, trainees will have the ability to know and put into practice:
-
What is the control unit (ECU) (CDI)
-
The types of control units (stock- Bosch, Denso, Mitsubishi, Kehin, Magneti Marelli) (Stand Alone- Fueltech, RapidBike, eTc)
-
What are fuel management modules (Powercommander, JetPRime, RapidBike, Bazzaz) etc.
-
How to identify a control unit (reference and software)
-
The various modes of reading a control unit (OBD2 diagnostic port, service mode ("pinout"), bench boot mode)
-
The tools needed to read and write on a Centralina
-
The Tools needed to edit a .bin file
Level 2 Training
Online or in person
Duration 8 hours
At the end of the course, trainees will have the ability to know and put into practice:
-
IMMO (immobilizer) concept
-
What is the bin file, basic and intermediate notions
-
What is the xdf file, basic and intermediate notions
-
Knowledge of the checksum concept of a control unit
-
Knowledge of editing, reading and writing software
-
Understanding integration in SH70XX (software for dense control units)
-
Understanding integration in TunnerPro software
-
Winols Basics (ECU Software Version Identification)
-
Editing maps in TunerPro - fuel by map , fuel TPS
-
Presentation and integration with the writing tool in command units
.jpeg)
Level 3 Training
In-person with Dyno Practice
Duration 16 hours
At the end of the course, trainees will have the ability to know and put into practice:
-
Fuel map/AFR adjustment depending on the exhaust system and filter fitted to the motorcycle.
-
Speed limiter removal.
-
Radiator fan temperature control.
-
Removing electronic exhaust probe errors; exhaust butterflies; pair valves; evap .
-
Adjust ignition maps
-
Adjust throttle/throttle opening maps
-
RPM Limiter Adjustment
-
Load adjustment on ignition coils.
-
Practical component on Dino and its control.
Sign up for T3 MotoPerformance's ECU reprogramming training today!
Do you dream of unleashing the full potential of your vehicle, exceeding the limits of speed and performance? Look no further, because T3 Moto Performance is about to ignite that passion of yours the way you want!
register here
Fill out the form to register for training
